CCNP 350-401 ENCOR Question 642 DISCUSSION
« Back to Main MenuRefer to the exhibit. An engineer must allow R1 to advertise the 192.168.1.0/24 network to R2. R1 must perform this action without sending OSPF packets to SW1. Which command set should be applied?
A.
R1(confg)# router ospf 1
R1(config-router)# no passive-interface gig0/0
B.
R1(config)# interface gig0/0
R1(config-f)# ip ospf hello-interval 65535
C.
R1(config)# router ospf 1
R1(config-router)# passive-interface gig0/0
D.
R1(config)# interface gig0/0
R1(config-if)# ip ospf hello-interval 0
Refer to the exhibit. An engineer must allow R1 to advertise the 192.168.1.0/24 network to R2. R1 must perform this action without sending OSPF packets to SW1. Which command set should be applied?
A.
R1(confg)# router ospf 1
R1(config-router)# no passive-interface gig0/0
B.
R1(config)# interface gig0/0
R1(config-f)# ip ospf hello-interval 65535
C.
R1(config)# router ospf 1
R1(config-router)# passive-interface gig0/0
D.
R1(config)# interface gig0/0
R1(config-if)# ip ospf hello-interval 0
Correct Answer: C
