CCNP 350-401 ENCOR Question 168 DISCUSSION

  • 757 views
  • 2023-06-24
« Back to Main Menu

Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show show command to verify operation. What does the output confirm?

Q168

A. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
C. RSPAN session 1 is incompietety configured for monitoring.
D. RSPAN session 1 monitors activity on VLAN 50 of a remote switch.

Refer to the exhibit. An engineer configures monitoring on SW1 and enters the show show command to verify operation. What does the output confirm?

Q168

A. SPAN session 2 monitors all traffic entering and exiting port FastEthernet 0/15.
B. SPAN session 2 only monitors egress traffic exiting port FastEthernet 0/14.
C. RSPAN session 1 is incompietety configured for monitoring.
D. RSPAN session 1 monitors activity on VLAN 50 of a remote switch.

Correct Answer: C

Support AceITCert.com by buying stuff you need!

1 Comments

ohhhvictor

SW1 has been configured with the following commands:

SW1(config)#monitor session 1 source remote vlan 50 SW1(config)#monitor session 2 source interface fa0/14 SW1(config)#monitor session 2 destination interface fa0/15

The session 1 on SW1 was configured for Remote SPAN (RSPAN) while session 2 was configured for local SPAN. For RSPAN we need to configure the destination port to complete the configuration.

Note: In fact we cannot create such a session like session 1 because if we only configure Source RSPAN VLAN 50 (with the command monitor session 1 source remote vlan 50) then we will receive a Type: Remote Source Session (not Remote Destination Session)

2024-03-21 00:14:34
In order to participate in the comments you need to be logged-in.
You can sign-up or login (it's free).